The Non-Linear Forming Limit Diagram-FLD成型極限圖類型

2017-07-26  by:CAE仿真在線  來源:互聯網

The Non-Linear Forming Limit Diagram

The Forming Limit Diagram (FLD) is the fundamental tool which is used to judge whether a formed sheet metal part is predicted to fail or pass, when analyzing simulation results. The “standard” FLD assumes a linear strain path, however, strain paths are not always linear in reality.

Non-linear strain paths usually begin occurring in secondary and subsequent forming operations, especially when the material is formed in the reverse or opposite direction. Therefore, if only a linear FLD is considered in a multi stage sheet metal forming simulation, it is possible that a non-linear failure mode may be overlooked. Therefore, non-linear FLD analysis is required in many cases before a sheet metal forming simulation can be given a “pass”. we uses AutoForm Incremental and non-linear FLD analysis is an integral part of this software. [Left: Standard Linear FLD. Right: Non-linear FLD showing additional failure mode]

If you are concerned that your simulation provider is not capturing non-linear failures, StampingSimulation can show you how to ensure this potential failure mode is not overlooked. Get started by contacting us OR by sending us your 3D product or tooling data. Non-linear analysis (when required) is always part of any SimulateLite or SimulateComplete simulation job.

相關標簽搜索：The Non-Linear Forming Limit Diagram-FLD成型極限圖類型 Autoform分析培訓班 Autoform汽車模具仿真 Autoform視頻教程 Autoform資料下載 在線軟件培訓 汽車鈑金代做 Fluent、CFX流體分析 HFSS電磁分析 Ansys培訓 Abaqus培訓 有限元培訓 Solidworks培訓